It is right between the motor and the hydraulic cylinder. If someone would be willing to check it for me, the part I am referring to is the longer of the two support arms that the saw pivots on. I called the parts suppler for these saws-American Fabricators/Ramco-and they were not able to get the measurment for me. I would like to confirm the measurment by checking another saw of the same model, but I don't know anyone who has one for me to measure. The saw frame does not sit at a true 45 degree angle to the table (looking from the end) and it appears that it would complete the cut better if the high side of the frame were up a little higher. I bought a Carolina Bandsaw (I think it is the HD10, but there is no label) a month ago and I have been trying to get it set up properly (a bigger job than I anticipated!) and I have come to the conclusion that one of the support arms, which is clearly non-original on my saw, may be the wrong size.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |